Hi. I've just successfully updated my firmware to 3.60 for the rebanding. Have verified this as the system first boots up. Whew! That is now done.
My question now involves the software to administer my scanner. Believe it or not, all I have right now is the original circa 2004 BearCat Scanner Software which was boxed on CD. It doesn't seem to me that I can use this old software to administer my scanner with the rebanding, right? PS: I've used the keypad on my scanner to update the 'Rebanding Table' and that seems to have gone ok. I've stopped here for a moment trying to figure out my next steps to actually input some channels/freq and talk groups, but I don't again believe my ancient software will do it. If not, what is the easiest, and hopefully cheapest software to buy which will support my scanner?
Thanks a ton. I'd really like to continue using my dusted off scanner here in Columbus, Ohio.
My question now involves the software to administer my scanner. Believe it or not, all I have right now is the original circa 2004 BearCat Scanner Software which was boxed on CD. It doesn't seem to me that I can use this old software to administer my scanner with the rebanding, right? PS: I've used the keypad on my scanner to update the 'Rebanding Table' and that seems to have gone ok. I've stopped here for a moment trying to figure out my next steps to actually input some channels/freq and talk groups, but I don't again believe my ancient software will do it. If not, what is the easiest, and hopefully cheapest software to buy which will support my scanner?
Thanks a ton. I'd really like to continue using my dusted off scanner here in Columbus, Ohio.
296D Rebanding Question
Aucun commentaire:
Enregistrer un commentaire