Does anyone have experience of decoding the output of an Icom IDAS repeater using DSD+.
Normally for a Kenwood Nexedge setup I'd expect to see CB decodes on the repeater output:
Sync:+NXDN48 CB VOICE e:1
Sync:+NXDN48 CB VOICE e:5r
Sync:+NXDN48 CB VOICE e:11
Sync:+NXDN48 CB VOICE e:3
Sync:+NXDN48 CB VOICE
Sync:+NXDN48 CB VOICE e:1
Sync:+NXDN48 CB VOICE
........and CS decodes on the input frequency:
Sync:+NXDN48 CS VOICE
Sync:+NXDN48 CS VOICE e:1
Sync:+NXDN48 CS VOICE e:31
Sync:+NXDN48 CS VOICE e:27r
Sync:+NXDN48 CS VOICE e:2121
Sync:+NXDN48 CS VOICE e:4r3
Sync:+NXDN48 CS VOICE e:1
Sync:+NXDN48 CS VOICE e:2
However for this Icom setup it shows BOTH input and output as CS, eg.
Sync:+NXDN48 CS VOICE e:1
Sync:+NXDN48 CS VOICE e:1
Sync:+NXDN48 CS VOICE
Sync:+NXDN48 CS VOICE e:6r4r2
Sync:+NXDN48 CS VOICE
Sync:+NXDN48 CS VOICE
Sync:+NXDN48 CS VOICE e:11
In this particular example, I know that the portables are Kenwood NX220s but the repeater is an Icom.
Anyone know if this is a one off or normal behavior?
Jim
Normally for a Kenwood Nexedge setup I'd expect to see CB decodes on the repeater output:
Sync:+NXDN48 CB VOICE e:1
Sync:+NXDN48 CB VOICE e:5r
Sync:+NXDN48 CB VOICE e:11
Sync:+NXDN48 CB VOICE e:3
Sync:+NXDN48 CB VOICE
Sync:+NXDN48 CB VOICE e:1
Sync:+NXDN48 CB VOICE
........and CS decodes on the input frequency:
Sync:+NXDN48 CS VOICE
Sync:+NXDN48 CS VOICE e:1
Sync:+NXDN48 CS VOICE e:31
Sync:+NXDN48 CS VOICE e:27r
Sync:+NXDN48 CS VOICE e:2121
Sync:+NXDN48 CS VOICE e:4r3
Sync:+NXDN48 CS VOICE e:1
Sync:+NXDN48 CS VOICE e:2
However for this Icom setup it shows BOTH input and output as CS, eg.
Sync:+NXDN48 CS VOICE e:1
Sync:+NXDN48 CS VOICE e:1
Sync:+NXDN48 CS VOICE
Sync:+NXDN48 CS VOICE e:6r4r2
Sync:+NXDN48 CS VOICE
Sync:+NXDN48 CS VOICE
Sync:+NXDN48 CS VOICE e:11
In this particular example, I know that the portables are Kenwood NX220s but the repeater is an Icom.
Anyone know if this is a one off or normal behavior?
Jim
Aucun commentaire:
Enregistrer un commentaire